#5 Swan-neck JC tool, 10mm cutter, 5/8in shaft, wood handle

£118.98 inc VAT£99.15 excl VAT
Part Number:
HT5003
Brand:
Hunter Tool
Add to Wishlist

Product description

Based on the HT5001 straight hollowing tool, this swan-necked tool enables easy undercutting, such as in the neck area, when working in larger hollow forms. The profiled tapered shaft on this tool coupled with the skewed orientation of the micrograin carbide tip give the tool amazing agility, with the ability to get into deep hollow forms yet work without vibration. At the same time it is perfectly at home working inside bowls if you require an undercut bowl rim.

The swan-neck on this tool bends to the left when viewed from the operator's position: it is designed for working on the inboard side of the headstock with the bowl rotating in the conventional (counter-clockwise) direction.

NB: This tool is also known as the Badger Hollowing tool in the US.

Item Ref.: HT5003

Manufacturer: Hunter Tool Systems, USA

Cutter Diameter: 10mm

Overall Length: 24.5 in.

Shaft Length: 7.5 in.

Shaft diameter:

Handle Length/Material: 17 in. inch Ash

All dimensions, stated in inches, are approximate and subject to change without notice

About Hunter Tool

Hunter Tool Company is known as an outstanding tool supplier of tools for hollowing work

The Hunter Tool uses a very fine grain of carbide specifically engineered to meet the sharptooling requirements demanded by the woodturning community.

While proficient in rough turning operations, Hunter Tools excel best when used as a finishing tool for final shaping and the light finish cuts. Often the tedious sanding operations are either eliminated or greatly reduced.

Carbide tools had been tried before in woodturning, but no-one previously seemed to have recognised that whilst carbide is very tough and highly wear resistant is is capable - normally - of being brought to only a moderately sharp edge. Key to the Hunter development was to apply the micro-fine diamond finishing process to the carbide tips to bring them to a sharpness comparable with that of conventional turning tool material, but with the added plus of long edge-holding and incredible wear resistance. 

True, these "jewels" of the carbide industry cost a little more than ordinary tips but it won't take mentions of silk purses and sow's ears to make you realise that the little extra is what makes these the only tips worth considering for woodturning. Sure, you can create "wood-shovels" with ordinary carbide tips, but you can't create what any self-respecting woodturner would call a turning tool capable of fine finishing as well as excavator-scale rates of material removal.